Switch Bottom Box Hardware Pressed Packaging Production Line

Introduction:

  • The equipment is mainly used for pressing metal parts of switch boxes and packing and palletizing. 
  • The main functions of the device are: turning the bottom box of the switch after discharging from the injection moulding machine, automatic feeding of the bottom box of the switch, pressing of hardware, product detection after pressing, thermal shrinkage of the cover film of the bottom box of the switch, automatic opening, automatic packing, automatic labeling, automatic sealing, automatic bundling and stacking. 
  • The device can adapt to the production of two different specifications of switch boxes, and achieve the purpose of flexible production for customers.

Parameters:

• UPH: 1450Pcs / H 

• Utilization rate: ≥85%

• Defect rat: ≤3% (except for not good incoming materials) 

• Dimensions: length x width x height 2600x2000x1700mm (specifically based on actual design dimensions) 

• Applicable voltage: AC220V 50Hz

• Applicable air pressure: 4~6Kgf/cm2

• Complete line power: ≤3 KW 

• Air consumption: 500L/H 

Characteristics:

  • Fully automatic operation, only manual feeding of vibration disc, simple operation, saving manpower 
  • Make appropriate control programs and use touch screen to control and adjust. 
  • The control program is easy to operate and can be modified according to the production process on site. 
  • Establish monitoring, alarm information and clear prompt to realize automatic shutdown of material shortage and failure 
  • Ensuring safe operation coefficient of equipment, emergency stop, automatic power cut, installation of anti-mistake touch isolation facilities 
  • Every dangerous area is pasted with protective and warning signs, and acrylic protective panels are added in moving and overturning operation areas.